Create macOS Sierra Bootable USB Installer on Windows 10
To create a Bootable USB Installer, you need to download macOS Sierra image file from the link below and other data that mentioned in the download section with an 8 or higher USB flash drive. The download process is a little bit complicated if you are not known to mega because you have to download it from there, also the credit goes to a Brazilian Hackintosh group. Note: This method works on Windows 7/8/10, and it’s not the TransMac process. Step #1. Firstly, download the following materials from the link below.
Download macOS Sierra image file (Updated) Download Win32DiskImager Download “Pacote de config”
Step #2. After downloading macOS Sierra image file from the link below Extract it with 7-Zip, Winrar or any other extractor. Step #3. Now Install Win32 DiskImager, open the Win32DiskImage.exe file then click next, next couple of times and other necessary installation steps, like license agreement. Step #5. When the installation process completed, click Finish to exit the setup wizard. Step #4. Run Win32DiskImager as admin and select your USB flash drive that wants to use as a bootable device for macOS Sierra 10.12. Step #6. After selecting a device, click on the folder icon beside the device selection option and browse the macOS Sierra image file that you downloaded from the link above. Firstly change the view mode to ( . ) then select Install macOS Sierra and click Open. Step #7. So after selecting the image and USB, click Write then it will show warning messages, click Yes to begin the Bootable USB Installer process. Step #8. Wait for Win32DiskImager to complete the Writing process to 100%. Step #9. After writing process finished, then you should get the Successful message like a shot below. Step #10. As mentioned above, download “Pacote de Config”. After downloading Extract it also by 7-Zip, Winrar or any other extractor. Step #11. Open “Pacote de Config” folder then select your PC if it’s desktop or laptop then from its folder, you will find some system graphics Config.plist file. Find & Copy the Config.plist that matches your Intell, AMD or NVIDIA system graphics. Note: Remember that if you didn’t find the exact config.plist file for your system, use one that approaches to your system. Like if your system graphics is Intel 4210 then choose above or below that because it mostly works, though many might fix your system and compatible with Hackintosh. Also, you might find your prepared config.plist file just by a quick googling. Step #12. Now go to your USB flash drive EFI > Clover then paste and replace the config.plist file that you copied from “Pacote de Config” folder with default plist file. Also Read: How to Create Bootable USB Installer for macOS Sierra via UniBeast? It was all about, how to create macOS Sierra bootable USB Installer on Windows 10. If you’ve any question or quiery, feel free to share it in the comment section down below.
